บอร์ดโดรน Betaflight Omnibus F4 V3 Flight Controller Board Built-in Barometer OSD TF Slot For FPV Quadcopter

คู่มือ ตามนี้ครับ
https://drive.google.com/file/d/1WEKbj9wLZAI8HYGQsU-Euj71J1bBTpwT/view?usp=sharing

Features:

-STM32 F405 MCU

-Dshot support

-Drag and Drop OSD configured via Betaflight Configurator

-Smartaudio v2 support ndash Tune your PIDrsquos and configure the omnibus F C from your Transmitter

-MPU6000 6 axis SPI Gyro & Accelerometer

-SBUS/PPM AND Spketrum dsm-x Ports

-MicroSD card blackbox

-Baro(BMP280)

-5v3a SBEC

-On-board Video Filter(only can supply 5V to VTX and Camera)

-SmartAudio V2 via tx6 on J10

-4times3 pin ESC pin layout

-IR pins for lap timing transponder

Package included:

1* F4 V3 Flight Controller

Standard Flight Control Mounting Hole 30.5X30.5mm Form Factor 36X36mm * Integrated 5V 3A BEC * BF Opens 32K Compatible with Mainstream BF CF Firmware * Reserved PWM Ports, Multiport Settings Supports PWM SBUS PPM IBUS DSM2 Various Mainstream Receivers * Integrated OSD uses a firmware compatible solution that delivers four dampening rings to reduce resonance of the flight control sensor due to motor rotation.

1. Flight control equipped with F4 32K chip can support flight control at 32K speed flight calculation (to support the operation of DHOTS 150/300/600/1200 high speed digital signal conditioning, the two together to bring better flight results ) And then bring a powerful computing power and computing speed, so that players fly more simple, stable, smooth and secure. 

2. Direct Integration and Firmware Direct Parts Compatible with the supported OSD module solutions, you can directly adjust and set various OSD settings in the ground station. Use the firmware compatible OSD program. Do not need the player to write the OSD data and the firmware again. The demand to look at the data, battery voltage, flight current, time of flight and everything else necessary for practical parameters. Set simple, convenient. More than all kinds of personalized settings. 

3. Integrated 5V BEC flight control to support direct power input, with a more diverse wiring, installation of simple wiring

Factory default firmware: OMNIBUSF4SD

Equipped with PPM or SBUS receiver, you need to connect the machine jumper next to the 3-point jumper shorted to the corresponding direction, in order to normally detect the PPM or SBUS signal

SBUS signal configuration RX6, IBUS or DSM configuration RX1.

1, the standard flight control hole 30.5X30.5mm shape 36X36mm 
2, integrated 5V 3A BEC 
3, equipped with STM32 F405 chip compatible with mainstream BF CF firmware 
4, reserved for PWM port, multi-port settings support PWM SBUS PPM IBUS DSM2 various Mainstream receiver 
5, integrated OSD firmware compatibility program to support the latest firmware 
6, reserved for active buzzer, active programmable LED lights, voltage detection port. 
7, support SD card slot

8, built-in barometer

9, weight: 7 grams